advertisement
3.5 Service
Service
Initialization Mileage Info.
Exit
This feature is used to restore printer settings to defaults and display printer mileage information.
3.5.1 Initialization
Service 1/3 Initialization Initializing …
> Initialization
Mileage Info.
Exit
SELECT YES
MENU NO
The printer settings are restored to defaults as below once printer is initialized.
Note :
When printer initialization is done, please calibrate the gap or black mark sensor before printing.
Parameter
Speed
Default setting
TTP-2410M Pro : 6 IPS (152 mm/sec)
TTP-346M Pro/246M Pro/344M Pro : 4 IPS (101.6 mm/sec)
TTP-644M Pro : 3 IPS (76.2 mm/sec)
Density
Label width
Label height
8
4.00
”(101.6mm)
4.00
”(101.6mm)
Sensor type
Gap setting
Print direction
Reference point
Offset
Print mode
Gap sensor
0.12
”(3.0mm)
0
0,0(upper left corner)
0
Batch mode
Serial port settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code page 850
Country code 001
Clear flash memory No
Shift X
Shift Y
0
0
70
Gap sensor sensitivity
Bline sensor sensitivity
Language
3 (Will be reset. Need to re-calibrate the gap)
2 (Will be reset. Need to re-calibrate the gap)
English
IP address DHCP
3.5.2 Mileage Info.
Use this option to check the printed mileage (displayed in meter).
Service 1/3 Mileage: (m)
Initialization 4016
> Mileage Info.
Exit
Labels: (pcs.)
51698
71
advertisement
Related manuals
advertisement
Table of contents
- 6 1.1 Product Introduction
- 7 1.2 Product Features
- 10 1.3 General Specification
- 10 1.4 Print Specifications
- 11 1.5 Ribbon Specifications
- 12 1.6 Media Specifications
- 14 2.1 Unpacking and Inspection
- 15 2.2 Printer Overview
- 19 2.3 Operator Controls
- 20 2.4 Setting Up the Printer
- 21 2.5 Loading Ribbon
- 25 2.6 Loading the Media
- 37 2.7 Adjustment Knob
- 39 Pro/TTP-344M Pro models)
- 41 3.1 Setup Menu Overview
- 70 3.2 File Manager
- 72 3.3 Diagnostics
- 74 3.4 Language
- 75 3.5 Service
- 77 4.1 Start the Diagnostic Tool
- 79 Pro/TTP-344M Pro models)
- 79 5.1 Using USB interface to setup Ethernet interface
- 80 5.2 Using RS-232 interface to setup Ethernet interface
- 81 5.3 Using Ethernet interface to setup Ethernet interface
- 83 6.1 Common Problems
- 87 6.2 Mechanism Fine Adjustment to Avoid Ribbon Wrinkles