5.2 Using RS-232 interface to setup Ethernet interface. The Speaker Company TTP-2410M Pro, 644M Pro, 346M Pro

Add to My manuals
92 Pages

advertisement

5.2 Using RS-232 interface to setup Ethernet interface. The Speaker Company TTP-2410M Pro, 644M Pro, 346M Pro | Manualzz

5.2 Using RS-232 interface to setup Ethernet interface

1. Connect the computer and the printer with a RS-232 cable.

2. Turn on the printer power.

Note: This utility works with printer firmware V6.00 and later versions.

4. Select

“COM” as interface then click on the “Setup” button to setup the serial port baud rate, parity check, data bits, stop bit and flow control parameters.

5. Click on the

“Ethernet Setup” button from printer function of Printer Configuration tab to setup the IP address, subnet mask and the gateway for the on board Ethernet.

75

advertisement

Related manuals