Connecting Baker AWA-IV to the Baker ZTX accessory. SKF Baker AWA-IV 4 kV, Baker AWA-IV 12 kV, Baker AWA-IV 12 HO, Baker AWA-IV Series, Baker AWA-IV 2 kV

Using the Baker ZTX with Baker AWA-IV analyzers

Connecting Baker AWA-IV to the Baker ZTX accessory

1) Connect the AUX cable to the AUX/PP connector on the front panel of the Baker

AWA-IV and the AUX connector on the front panel of the Baker ZTX.

Figure 132. Connect AUX cable between AWA and ZTX.

2) Connect Baker AWA-IV test lead 1 to the TEST LEAD 1 receptacle located on the back of the Baker ZTX.

3) Connect Baker AWA-IV test lead 2 and 3, and the ground lead to the GND/L2/L3

LEADS receptacle on the back of the Baker ZTX.

Figure 133. Connect AWA test leads to ZTX.

134 PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual