Securing BSM-2 module. Simrad BSM-2

Securing BSM-2 module

Mount the BSM-2 on a vertical surface with the power and transducer cable entries exiting downwards.

Fasten the BSM-2 by using the 4 stainless steel self tapping screws included with the unit.

Wiring

General

The power and the transducer cables connect with screw terminals inside the BSM-2 unit. Refer wiring diagram and connection details on the following pages.

The BSM-2 contains high voltages and specialized parts; the operator should never remove the module’s cover without removing the power connection.

Removing the transducer cable from the BSM-2 while the module is powered on can cause sparks.

Remove the transducer cables only after the module has been disconnected from its power source.

8 | BSM-2 Installation manual

BSM-2_IM_988-0170-09_A.indb 8 2/14/2011 2:52:21 PM