advertisement
▼
Scroll to page 2
of
93
6.4.3 TCP/IP server.
You can configure the MFP Server to automatically get an IP address from
DHCP server or manually specify a static IP.
If you need the MFP server to automatically get an IP address from a DHCP server, select “Enable Obtain TCP/IP Settings Automatically (Use DHCP/
BOOTP)”. You also can select “Disable Use the following TCP/IP Settings” to manually assign an “IP Address”, “Subnet Mask” and “Gateway” for the MFP
52
advertisement
Related manuals
advertisement
Table of contents
- 12 Introduction
- 13 MFP server Modes
- 15 Using Your All-in-one
- 17 Printing
- 18 Scanning
- 20 Reading Memory Cards
- 21 MFP Manager
- 21 MFP Server List
- 24 My Favorite
- 26 Auto Connect List
- 29 Quick Setup
- 31 Option Settings
- 31 General Setting
- 32 Search for MFP server
- 33 Server Configuration
- 33 Introduction
- 34 Search for All Available MFP server
- 35 Status of MFP server
- 36 Set up the MFP server
- 37 General Configuration
- 38 TCP/IP Configuration
- 39 System Configuration
- 41 Wireless Configuration
- 46 MFP server Management
- 47 Report
- 48 Web Management
- 48 Introduction
- 49 Login
- 50 Device Status
- 50 System Status
- 51 Printer Status
- 52 TCP/IP Status
- 53 Setup Wizard
- 53 System
- 56 Wireless
- 63 TCP/IP
- 64 Save Settings
- 65 System Tools
- 65 Load Default
- 66 Upgrade Firmware
- 67 LPR Printing
- 74 RAW Printing
- 81 IPP Printing
- 81 Introduction
- 81 System Setup
- 81 MFP server Side
- 81 Client Side
- 86 MFP server Installation in MAC OS
- 86 MAC 10.4.x
- 87 MAC 10.3.x
- 91 Troubleshooting