Below you will find brief information for Pinnacle Stair Lift. This manual guides users through the comprehensive installation and service procedures for the stair lift system. It details everything from preliminary checks and tools required to rail installation, chassis setup, and final adjustments. The document also covers remote control operation, setting travel limits, testing safety stop switches, and folding rail installation and conversion, ensuring thorough understanding for safe and proper operation of the device.
Advertisement
Advertisement
Advertisement
Step-by-step installation procedures for rail and chassis
Remote call/send control operation with reprogramming instructions
Adjustable upper and lower travel limits for customized fit
Comprehensive safety stop switches for obstruction detection
Optional folding rail installation and conversion procedures
LED indicator light for system status and safety alerts
Adjustable seat height for user comfort
Battery charger for continuous operation
A cordless drill, Allen wrenches (5/64”, 5/32”, 3/16”, 5/16”), Phillips screwdriver (#3), Nut driver (3/8” and 5/16”), 6-10” driver extension, T30 Torx bit (included), level, hacksaw or chop saw, SAE socket set, SAE wrenches, and tape measure are suggested.
Measure the overall length of the stairs from the nose at the top landing to the floor at the bottom, then add 13” to this measurement. This ensures enough rail length for proper seat height adjustment at both ends.
A yellow LED indicator light means that one of the system controls or safety sensors is currently engaged.
Start with the red 'ON/OFF' switch in the 'OFF' position, disconnect the 6-pin footrest and 8-pin chair wire harnesses, press and hold the install switch, turn the 'ON/OFF' switch to 'ON', release the install switch, then press 'UP' or 'DOWN' on each remote control.
The underside of the rail must be at least 2 inches above the stair tread nose to provide adequate clearance for the footrest.
What to do if the chair lift remote control is unresponsive?
If the chair lift fails to respond to the remote control, the batteries may be discharged and need replacement. Remove the back cover of the control and replace the batteries with commonly available AAA batteries, ensuring correct polarity.
What to do if the chair lift remote control is not working?
If the chair lift fails to respond to the remote control, the batteries may be discharged and need replacement. Remove the back cover of the control and replace the batteries with commonly available AAA batteries, ensuring correct polarity.
What to do if the stair lift doesn't respond to the remote control after replacing the batteries?
The remote call/send controls may need to be re-programmed. Remember to program both controls in one programming cycle. If the problem continues, further troubleshooting may be needed.
What should be done if the stair lift does not respond to the remote control, even after replacing the batteries?
The remote call/send controls may need to be re-programmed. The manual provides a detailed, step-by-step guide of how to re-program the remote call/send controls. It is essential to program BOTH controls in one programming cycle. If issues persist, further troubleshooting steps or professional assistance may be required.
What to do if the remote control of a chair lift is not working?
If the chair lift isn't responding to the remote control, the batteries might be low. Try replacing them with new AAA batteries, making sure to put them in with the correct polarity.
What to do if the stair lift doesn't respond to the remote control after replacing the batteries?
The remote call/send controls may need to be re-programmed. The manual provides a detailed, step-by-step guide of how to re-program the remote call/send controls. It is essential to program BOTH controls in one programming cycle. If issues persist, further troubleshooting steps or professional assistance may be required.
What to do if the remote control is not working?
If the chair lift fails to respond to the remote control, the manual indicates that the batteries may be discharged and need replacement. Remove the back cover of the control and replace the batteries with commonly available AAA batteries, ensuring correct polarity.
