Set Lock Code. JVC I'Art Pro AV-56WP84, I'Art Pro AV-65WP84

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes preset with a lock code of “0000”. You may change the code to any four-digit number you wish.

To change the lock code, follow the steps below.

Press the M

ENU

button

To SET LOCK CODE

√ ® To operate (lock icon appears)

Press Z

ERO

to access the lock code

The first digit will be highlighted

√ ® To select the number

To move to the next digit

Continue to follow these directions for all four numbers

Press the OK button to finish (your lock code is now set)

Press the Menu button when finished

When a viewer attempts to watch a blocked channel, this message appears:

The channel will remain blocked until the correct lock code is entered (see above for information on setting your lock code).

Notes:

• After a power interruption you must reset the lock code.

• Write your lock code number down and keep it hidden from potential viewers.

• If you forget the lock code, a new code may be set using the steps listed above.

37

7/11/03, 9:32:48 AM AV-56\65WP84 English 37