CONFIGURATION. Enertronica Santerno Sinus Penta, SOLARDRIVE PLUS, IRIS BLUE, PENTA MARINE

USER MANUAL MOTOR DRIVES

ACCESSORIES

12.4.2. Configuration

Protocol

Default Baud

Default Station ID

Fieldbus Port

Inverter Port

MetasysN2 MODBUS RTU

9600 8N1

11

38400 8N2

1

12.4.3. RS485 Connector

The communications port includes a positive pole (+), a negative pole (-) and the ground (G).

Figure 115: RS485 connector for Metasys ® N2

12.4.4. LEDs on the ASP485 ProtoCessor Module

BLUE

[L8] [L7]

COMMS

ORANGE

[L6]

RUN

[L5]

YELLOW

[L4] [L3]

NO DEFAULT

RED

[L2] [L1]

ERROR

LED COLOUR DESCRIPTION

L8

L7

L6

BLUE

BLUE

ORANGE

ON: Field Port packet received

OFF: Field Port response sent

ON: Inverter Port Send Poll

OFF: Inverter Port Receive Valid Response

ON (flashing 2Hz) : ProtoCessor is running normally

OFF: ProtoCessor is not running

L5 ORANGE Not Used

L4

L3

L2

L1

YELLOW

YELLOW

RED

RED

ON: MODBUS Slave address set by DIP-switch

OFF: MODBUS Default Address at factory default = 11

ON: Baud Rate set by DIP-switch

OFF: Baud Rate at factory default = 9600

ON: Bad Poll, No Map Descriptor found

OFF: Once Exception response has been sent [*]

ON: Panic

OFF: No Panic has occurred

[*] If you receive a poll for data that does not exist, you turn that LED on briefly.

Basically, the system received a valid poll, but could not find a corresponding data point.

219/ 312