Disposal Requirements Under WEEE Regulations. Beijer Electronics BoX2 extreme
Add to My manuals28 Pages
advertisement
8
Safety Precautions
X: 表明该有害物质至少在部件的某一均质材料中的含量超出 SJ/T 11363–2014 规定
的限量要求。
1.3 Disposal Requirements Under
WEEE Regulations
For professional users in the European Union: If you wish to discard electrical and electronic equipment (EEE), please contact your dealer or supplier for further information.
For disposal in countries outside of the European Union: If you wish to discard this product please contact your local authorities or dealer and ask for the correct method of disposal.
1.4 UL and cUL Installation
• All devices have to be supplied by a Class 2 power supply.
Warning:
Do not separate when energized.
AVERTISSEMENT, NE PAS SEPARER SOUS TENSION.
Warning:
Do not open when an explosive atmosphere is present.
NE PAS OUVRIR SI UNE ATMOSPHERE EXPLOSIVE EST PRÉSENT.
Warning:
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
This product contains a battery that is not user replaceable.
LA BATTERIE PEUT EXPLOSER EN CAS DE MAUVAISE MANIPULATION.
NE LA RECHARGEZ PAS, NE LA DÉMONTEZ PAS ET NE LA JETEZ
PAS DANS LE FEU.
CE PRODUIT CONTIENT UNE PILE QUI NE PEUT PAS ÊTRE
REMPLACÉE PAR L'UTILISATEUR.
Warning:
Potential electrostatic charging hazard, see instrucions.
To avoid electrostatic charge build-up, it must not be rubbed or cleaned with solvents or a dry cloth when installed/used within a potentially explosive atmosphere.
POTENTIEL ÉLECTROSTATIQUE RISQUE DE CHARGEMENT,
VOIR INSTRUCTIONS.
Beijer Electronics, MAEN276
advertisement
Related manuals
advertisement
Table of contents
- 7 1 Safety Precautions
- 7 General
- 7 Hazardous Materials
- 8 Disposal Requirements Under WEEE Regulations
- 8 UL and cUL Installation
- 9 IECEx/ATEX Certificate and Dust Rating
- 9 Conditions of Safe Use for Zone 2/22 ATEX/IECEx
- 9 During Installation
- 10 During Use
- 10 Service and Maintenance
- 10 Dismantling and Scrapping
- 11 2 Installation
- 11 Installation Process
- 13 Protective Connector Shield Installation Process
- 14 Connections to the Controller
- 14 Other Connections and Peripherals
- 15 3 Technical Data
- 17 4 Chemical Resistance
- 17 Metal Casing
- 19 5 Operator Panel Drawings
- 19 Connectors
- 19 Power Supply
- 19 COM A
- 20 LAN A / LAN B
- 20 COM B
- 21 BoX2 extreme Outline
- 23 6 Additional Installation Tips
- 23 Grounding the operator panel
- 23 To Achieve Better EMC Protection
- 25 Safety
- 26 Galvanic Isolation
- 27 Cable and Bus Termination RS