Presentation of the Electronic Cam Module
Physical Presentation of the Module
Introduction The connectors for the I/O interfaces to the machine are on the front panel of the module. The connector for linking to Bus X is at the rear of the module. All the control data and signals from the processor travel via this bus.
View of the
Module
The diagram below shows the TSX CCY 1128 module with its various elements.
TSX CCY 1128
1
2
3
5
6
4
7
5
Presentation of the Electronic Cam Module
Physical Presentation of the Module, continued
Elements and
Their Functions
Number Element
1 Screw
2 Module casing
3 Display block comprising
4 LEDs:
Function
Attaches the module to the TSX RKY •• rack
Performs the following functions:
• Supports and protects the electronic cards
• Attaches the module in its slot
• Supports the connectors
Display the module states and faults, and the channel diagnostics.
6
7
4
5
• green RUN LED
• red ERR LED
• red I/O LED
• green CH0 LED
15-pin SUB D connector
HE 10 connector
HE 10 connector
HE 10 connector
Indicates the module operating mode
Indicates a module internal fault
Indicates a fault which is external to the module or an application fault
Used for channel diagnostics.
(The states of the lamps and their meanings are described in chapter 6).
For connecting to the encoder.
For connecting the group 0 and 1 track outputs
For connecting the group 2 and 3 track outputs
For connecting the auxiliary outputs and the encoder power supply
6
