Inserting the RD Roll. Brother TD-2120N, TD-2020/2020A, TD-2130N

Chapter 2

Inserting the RD Roll

2

Use genuine Brother roll media.

Genuine Brother fanfold media is not available at this time.

a

Press and hold the (Power) button to turn the printer off.

Press the cover release lever (1) on either side and lift up to open the RD

Roll compartment top cover.

c

Insert an RD Roll into the RD Roll compartment, and then close the RD

Roll compartment top cover.

 For an RD Roll

1 Insert the RD Roll so that the labels feed with the side to be printed on facing up (1), as shown.

1

1 b

Open the media guides by lifting up the media guide adjustment lever (1) and pulling the media guides outwards.

1

NOTE

The media guides are shipped fully open from the factory.

15

 Use RD Rolls with an outer roll dimension of 5" (127 mm) or less.

Use RD Rolls designed for TD series printers. Regardless of the size, some RD Rolls may not be usable.

 Insert the RD Roll facing the correct direction. If the RD Roll is not inserted correctly, the printer will not print on the correct side of the paper or label.

 When using media with the labels rolled up on the inside, insert the roll in the opposite direction of that shown in sub-step 1 of step

c

so that the print side of the labels will face up.

2 While lifting up the media guide adjustment lever (1), push in both media guides (2) to fit the width of the paper.

Printing

5 Close the RD Roll compartment top cover by pressing it in the center.

Press down until it snaps into place.

2

1

2

3 Feed the end of the RD Roll under the media tip guides (1).

1

 For fanfold paper

1 Insert the fanfold paper in the direction shown.

1

4 Position the end of the paper centered over the platen roller and slightly out of the media exit.

1 Print side

16