replace. MULTIQUIP Rammax 1575

The Rammax 1575 is a trench roller specifically designed for compacting trenches. This model features a Yanmar 3TNV76 diesel engine and is equipped with 24-inch drums. The Rammax 1575 is capable of a variety of tasks including compacting soils, gravel, and other materials in trenches. It's designed for both field and shop service and covers maintenance, repair and machine descriptions.

PDF

Document

Pull the drive motor complete with the auxiliary tool away from the gear box.

Fig. 10-297 201309270038

Fig. 10-298 201309270039

Set the drive motor down securely until needed again.

Fig. 10-299 201309270040

10.15.2 replace

Fig. 10-300 201309260073

222

Fig. 10-302 201309260078

Completely remove all of the screw connections from the demounted drive motor.

Fig. 10-301 201309260076

Remove the seven M12x25 Allen screws (AF size 10) from the drive motor flange.

Screws inaccessible:

In infrequent cases, the seven M12x25

Allen screws are not accessible, which means that the drive motor flange must be completely removed. In this case, the five hex screws (AF size 24) must be removed.

Lift the flange from the drive motor.

Rammax 1575

Screw two eye bolts into the drive motor flange.

Fig. 10-303 201309260079

Fig. 10-304 201309260080

Fig. 10-305 201312180001

Attach the tackle to the crane and the eye bolts.

The orientation of the drive motor must be marked with a marker before the drive motor is lifted out of the motor support.

If the drive motor is rusted in place in the motor support, the drive motor must be pressed out of the motor support:

Clean three threads.

Retap three threads.

Install three M12x60 hex screws.

Press the drive motor out of the motor support.

Lift the drive motor out of the motor support.

Fig. 10-306 201309260083

Replacing the drive motor

Repair 223

Clean the bearing surface and the threads.

Fig. 10-307 201309260085

1 Apply Anti-Seize to the seat of the bearing on the drive motor support.

224

Fig. 10-308 201309260086

Put a little blue adhesive into the threaded bores.

Fig. 10-309 201309260087

Place the new drive motor into the motor support.

1.1

Bear in mind the orientation of the motor (marked previously).

Fig. 10-310 201309260083

Rammax 1575

Apply blue adhesive to the

six M12

Allen screws.

Fig. 10-311 201309260089

Install the Allen screws.

Fig. 10-312 201309260091

Tighten the Allen screws (SW10) to a torque of 85 Nm.

Fig. 10-313 201309260092

Apply blue adhesive to the screw connections from the old drive motor.

Fig. 10-314 201309260093

Replacing the drive motor

Repair 225

Key features

Yanmar 3TNV76 diesel engine
Robust vibratory system
Trench compacting capability
Control options for ease of operation
Versatile for various trench compaction tasks

Frequently asked questions

The maximum climbing capacity of the Rammax RX1575 is 40% with vibration and 50% without vibration, as mentioned in the viewed document.

The maximum vibration frequency of the Rammax RX1575 is 2,460 Hz, as mentioned in the viewed document.

The instructions for adjusting the rubber hood buffers are detailed in the viewed document.

The front chassis number is located under the steering/Vibro pump, and the rear chassis number is located hidden on the rear-most part of the center beam, as mentioned in the viewed document.

The instructions for draining the hydraulic oil are detailed in the viewed document.