Introduction . Omron NB-series NB7W-TW00B, NB-series NB5Q-TW00B

Below you will find brief information for NB-series NB5Q-TW00B, NB-series NB7W-TW00B. This manual describes the methods used to install the NB Unit and connect peripheral devices. It also includes information on the System Setting Mode, Calibrate Mode, and maintenance and troubleshooting procedures.

PDF
Document
OMRON NB-series NB5Q-TW00B, NB-series NB7W-TW00B SETUP MANUAL | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Touch panel control

  • RS-232C/RS-485/RS-422A communication

  • System Setting Mode

  • Calibrate Mode

  • Downloader Mode

  • User Project Mode

  • Reset switch

Frequently asked questions

The NB Unit must be installed in a control panel. The mounting panel must be between 1.6 and 4.8 mm thick. Tighten the Mounting Brackets evenly to a torque of between 0.5 and 0.6 N·m to maintain water and dust resistance.

The NB Unit has four operating modes: System Setting Mode, Calibrate Mode, Downloader Mode, and User Project Mode. The mode is selected using the DIP switch on the back of the unit.

The NB Unit can be connected to a PLC using the serial port COM2. The port supports RS-232C/RS-485/RS-422A communication.

Refer to the troubleshooting section of this manual for information on common problems and their solutions.

User questions

O J

Patricia O.

How to adjust the system time on the NB series touchscreen?

There are two methods: 1. Set DIP switches SW1 and SW2 to ON, reset the device to enter System Setting Mode, and update the values manually. 2. Use NB-Designer to map Number Input components to internal addresses LW10000 through LW10006 (representing seconds, minutes, hours, day, month, year, and week) to allow real-time modification during operation.

Preparing document for printing…
0%