Flooding Water Handle. ICECAT GAS/PRO 220

The ICECAT GAS/PRO220 Ice Resurfacer is a powerful and efficient machine designed for resurfacing ice rinks. It features a robust design, a powerful engine, and a user-friendly control panel. This manual provides comprehensive instructions on operating and maintaining the machine for optimal performance and longevity. The ICECAT GAS/PRO220 Ice Resurfacer is equipped with a wide range of features, including a robust snow tank, a powerful auger, and a water spreading towel, making it ideal for maintaining ice rinks of various sizes.

PDF

Document

Key features

Powerful engine
Robust snow tank
Water spreading towel
Side brush
User-friendly control panel

Frequently asked questions

Open either the gasoline tap in the gasoline tank (GAS220 machines) or LPG bottles (PRO220 machines), depending on your machine. Then, check that the ignition key is in its leftmost position, the direction selector is in its middle position, the motor rotation speed is low, and all buttons are in their upper or middle positions. Turn the ignition key to the right and finally, turn it to the extreme right to start the motor. Allow the motor to run for 30 seconds before starting work.

Place the sled on supports and place boards under the blade. Remove the cover sheets from the sled, open the screws that attach the blade, and let the blade fall onto the boards. Remove the old blade and lift the new blade onto the boards. Push the new blade under the sled and tighten the mounting screw.

For a new machine, the oil must be changed after 100 hours of operation. For subsequent changes, change the oil every 500 hours of operation. If the machine is not used for an extended period of time, check the oil quality and change it if necessary.