Roland MV8800 Manual

Storing the current effect settings in the library

After you’ve edited the effect parameters to create your own effect settings, you can store them in the library and recall them later when needed.

1.

Press [EFFECTS].

The EFFECT screen will appear.

2.

Move the cursor to the effect that you want to store in the library.

3.

Press [F3](Library).

The screen that appears will depend on the current effect.

Current effect

MFX

Dly/Cho

Reverb

Screen that appears

MFX LIBRARY popup (Screen Guide; p. 230)

DELAY/CHORUS LIBRARY popup (Screen Guide; p. 230)

REVERB LIBRARY popup (Screen Guide p. 230)

4.

Turn the VALUE dial or use [DEC] [INC] to select the user area number in which you want to store your settings.

The user area is the section of memory in which you can store your own settings. The user area consists of the effect library numbers preceded by a “U” character.

●

For details on the number and structure of the effect library, refer to “Preset Patches and Algorithm List”

(Appendices; p. 14).

●

You can’t save settings in the preset area (effect library numbers preceded by a “P”).

5.

Press [F1](Write Here).

A message of “Write current to U###. Are You Sure?” will appear. (## is a effect library number.)

6.

Press [F5](Yes).

The current effect settings will be written into the effect library number you selected.

●

Once you overwrite a library number, there’s no way to recover its previous contents. You may want to save the user library to disk before you overwrite your own settings.

M-212

MV-8800 Owner’s Manual