1. Attaching the anti-tilt brackets. Gaggenau RC 472, RC 462, RF 463, rc 462/413 rf 411/413 rf 461/463 rf 471 rw 414/464, RF 413, RW 464, RF 461, RF 411, RF 471, RW 414

1.

Attaching the anti-tip brackets

ã

WARNING

Risk of injury and damage!

Assure that there are no electrical wires or plumbing in the area which the screws could penetrate.

ã

WARNING

Risk of injury! Always wear safety glasses and other necessary protective devices or apparel when installing or working with dowels.

Important note:

If a Side-by-Side set up of two appliances is envisaged, the anti-tip brackets are needed as installation aid.

Connect the appliances before the anti-tip brackets are fixed to the wall, see “Side-by-Side installation”.

Notes:

– Each appliance requires 2 anti-tip brackets.

– The set supplied, contains fastening screws for various subsurfaces. Select the fastening screws corresponding to the local conditions.

– If the anti-tip brackets, and therefore the appliance, cannot be securely attached with the supplied fastening screws, another suitable method must be used to attach the appliance securely.

The anti-tip-brackets (a) must overlap a minimum of

2

1

/

8

” (54 mm) over the appliance to secure the appliance.

If this minimum length cannot be observed for structural conditions it is possible to do this by fastening a spacer (b) behind the anti-tip angle, e.g. a sufficiently dimensioned wood board.

1. Specify the attachment points of the anti-tip-brackets according to the section on “Dimensions of the installation niche”.

2. Attach the anti-tip-brackets completely.

Be sure screws hold tight.

The length of the plank should correspond to the width of the installation niche!

Important notes for fastening with dowels and screws:

– Not recommended for use in light-weight masonry material such as cinder block.

– Not recommended for use in new concrete which has not had time to cure.

– Do not use spiral-flute counterbores (countersinking tool) to drill the holes.

13