- Computers & electronics
- Computer components
- Interface components
- Serial switch boxes
- GSS
- GSS.remote RLC 8
- User manual
advertisement
7 r emote aCCess via
i nternet
To get remote access via internet the router connected to the RLC 8 must be connected to the internet. In addition the "public" IP address with which the router is connected to the internet must be known.
—> Therefore you either need a "fixed", "static" public IP address, or a DNS account which you can get from respective providers of dynamic DNS services (e.g. DynDNS.com).
For remote maintenance via internet "Port Forwarding" must be configured at the router.
—> Pay attention for the operating instruction of the router.
—> If several RLC 8 are used, for each port used "Port Forwarding" must be configured.
—> To get remote access via internet you need a PC with internet access
• Start the PSW 1000 software.
—> The installation of the PSW 1000 software is described in chapter
• Click the button.
—> The "Connection settings" window is activated.
• Select tab "Ethernet" and enter
• Select tab "Ethernet" and enter at a connection at a connection via the Internet the "external"
(public) IP address of the router or its "dynamic
DNS account" and the port of the router, for which port forwarding to the management system is configured e.g. IP 212.20.172.0 and port
59999
.
• If a password was set before enter the password
(case-sensitive).
• Click on button "OK".
- 18 - RLC 8
If no password is set, the following message appears:
• Click on button "OK".
—> The connecting button changes from to .
If you have entered a wrong password, the following message appears:
• Enter the password (case-sensitive).
—> The connecting button changes from to .
—> The password setting is to be done in menu Plant settings > Security
(PSW 1000).
- 19 - RLC 8
Declaration of CE conformity
GSS Grundig Systems GmbH • Beuthener Straße 43 • D-90471 Nuremberg
Phone: +49 (0) 911 / 703 8877 • Fax: +49 (0) 911 / 703 9210 www.gss.de/en • [email protected]
Service: Phone: +49 (0) 911/703 2221; Fax: +49 (0) 911/703 2326; [email protected]
Alterations reserved. Technical data E. & O.E. © by GSS Grundig Systems GmbH 001/2017
advertisement
Related manuals
advertisement
Table of contents
- 3 1 Safety regulations
- 3 2 General information
- 3 2.1 Packing contents
- 3 2.2 Meaning of the symbols used
- 4 2.3 Technical data
- 5 2.4 Description
- 6 2.5 PC / laptop system requirements
- 7 2.6 Overview of the management unit
- 8 3 Installation
- 8 Potential equalisation (PE)
- 9 3.2 Assembling a connection cable
- 9 3.3 Connecting components
- 10 4 Installing the software on a PC or laptop
- 10 3.1 Key Code (Activation Code) for the software
- 10 3.2 Installing the software
- 14 5 Connecting to a network
- 14 5.1 LAN configuration
- 16 5.2 Check the configuration at the control unit of the head-end station
- 17 6 Firmware update
- 18 7 Remote access via Internet