INSERTING AND REMOVING THE CF CARD. Sigma SD14

INSERTING AND REMOVING THE CF CARD

The SD14 camera uses CompactFlash™ (CF) cards to store images. The camera supports both Type I and Type II CF cards, including Microdrives.

TO INSERT THE CF CARD

1

Set the “D”-Dial to the position.

2

Open the CF card cover, as shown in the illustration.

3

Position the CF card with the label facing toward the CF card cover and insert the CF card smoothly, in the direction of the arrow, as far as it can go into the slot.

• The eject button will pop out slightly.

4

Close the CF Card Cover and slide it in the direction shown by the arrow, until it clicks shut

TIP

•

It may be necessary to format the CF card before use. (See P.30)

28

TO REMOVE THE CF CARD

1

Set the “D”-Dial to the position.

• Make sure that the CF card busy light is off, before continuing.

2

Slide the CF Card Cover until it pops open.

3

Press the Eject button to eject the CF card.

4

Close CF Card Cover and slide it in the direction shown by the arrow until it clicks shut

CAUTION !!

•

Never do any of the following while the CF Card busy light is on. (The CF card busy light indicates when the camera is writing, reading, or erasing images from the CF card. Doing any of the following may cause image data to be lost or corrupted.)

1. Do not open the CF card cover or remove the CF card.

2. Do not open the battery cover or remove the battery.

3. Do not apply shocks or vibrations to the camera.

TIP

•

If the “D”-Dial is set to the position while the CF Card busy light is on, the camera will remain on until it is done processing images or accessing the

CF card.

29