Lifting pole. Vermeiren Luna X-low, Luna Basic, Luna, Luna Metal, Luna Deluxe

Luna

2010-11

If raising the side railings or covering these are required for additional security of the patient

(e.g. very skinny patient), it should be noted that no functions of the bed should be impaired, nor the CE-conformable implementation as when first delivered.







 

The overhead boom can be mounted on either side of the headrest (use only for LUNA!).

1 = Lifting pole

2 = Boom socket

3 = Locking bolts

4 = Insert nut

5 = Upper frame boom

6 = Socket holes

7 = Strap

8 = Triangle

Insert the boom (1) as far as it will go into the relevant socket (2).

Let the arresting bolts (3) slide into the groove (4).

Pull the metal loop over the end of the upper frame (5) until the bolts engage one of the three socket holes (6).

Also pull strap (7) into the metal loop and through the triangle (8); then fix its length.

Secure the strap.

2.10 Stop notch (when available)

CAUTION: Risk of injury - No people or objects allowed close to where adjusting is being done.

To adjust the lying surface of the lower leg, grip the foot-end toggle strap in the middle of the frame. Pull the lying surface of the lower leg to the desired height. The stop notch locks in distances of approx. 2cm. To lower the lying surface of the lower leg, use the foot-end toggle strap and pull it to the upper position. The stop notch will now stop locking and you can slowly completely let down the lying surface of the lower leg until it reaches the bed frame.

Perform adjustments only by means of the foot-end toggle strap to avoid tilting or damage to the frame adjustors.

Page 12