Operating and installation instructions Oven

Cleaning and care

At the end of pyrolytic cleaning

When the duration remaining reaches

0:00 h, a message will appear in the display to tell you that the door is unlocking.

When the door lock has been released:

– Process finished will appear.

– A buzzer will sound if the buzzer is switched on (see "Settings – Volume

– Buzzer tones").

 Switch the oven off.

The visual and acoustic signals are switched off.



Danger of burning.

Wait until the oven has cooled down before removing residual soiling left in the oven compartment from pyrolytic cleaning.

 Wipe any residues (e.g. ash) left behind after the Pyrolytic cleaning programme out of the oven compartment and wipe any residues off any pyrolytic accessories. The amount of ash will vary depending on how dirty the oven was.

Most soiling can be easily removed using a clean, damp microfibre cloth, or with hot water and a little washingup liquid on a clean sponge.

Depending on how dirty the oven was there may be a visible layer of soiling across the inner glass pane on the door. This should be removed using the reverse of a non-scouring washing-up sponge or with a stainless steel spiral pad and a little washing-up liquid.

118

 Extend and retract the FlexiClip telescopic runners several times after running the Pyrolytic cleaning programme.

Please note:

– The fibre glass seal around the front of the oven should be handled carefully. Do not rub and scour it. If possible you should avoid trying to clean it.

– After pyrolytic cleaning the FlexiClip telescopic runners may appear discoloured or a lighter colour in some places. This will not affect the functioning of the runners in any way.

– Spilt fruit juices may cause lasting discolouration to enamelled surfaces.

This discolouration is permanent but will not affect the efficiency of the enamel. Do not attempt to remove these marks.