Schedule. Air Live SD-2020

6. System

6.13 Schedule

This function allows the users to setup schedules for features including: <Alarm Switch>,

<Motion Detection> and <Network Failure Detection>. The function supports up to 10 sets of time frames in the time frame list.

- Setting Schedules

To set a schedule, please select a time frame from the time frame list first. Then check the boxes from below to choose the specific weekdays. At last, type in the start time

(hour:minute) and the duration time (hour:minute) for activation of the schedule triggered features. The setting range for the duration time is from 00:00 to 168:59. Click

<Delete> to delete a chosen time frame. Please click on <Save> to save the setup.

NOTE: Users MUST select <By schedule> under each feature setting page to enable the schedule function.

57 AirLive SD-2020 User’s Manual