Factory Default. Air Live SD-2020

6. System

- Parameter List

6.16 Factory Default

Users can follow the instructions on this page to reset the IP Camera to factory default settings if needed.

- Full Restore

Click on the <Full Restore> button to recall the factory default settings. Then the system will restart in 30 seconds.

NOTE: The IP address will be restored to default.

- Partial Restore

Press the <Partial Restore> button to recall partial default setting. Then the system will restart in 30 seconds.

NOTE: The IP address will not be restored to default.

- Reboot

Click on the <Reboot> button, and the system will restart without changing current settings.

61 AirLive SD-2020 User’s Manual