Cisco IOS XR System Monitoring Command Reference for the Cisco

IP Service Level Agreement Commands responder

responder

To enable the IP SLA responder for UDP echo or jitter operations, use the responder command in IP SLA configuration mode. To disable the responder, use the no form of this command.

responder no responder

Syntax Description This command has no keywords or arguments.

Command Default The IP SLA responder command is disabled.

Command Modes IP SLA configuration

Command History

Release

Release 3.3.0

Release 3.3.0

Release 3.7.2

Release 5.2.3

Modification

This command was introduced.

This command was introduced.

This command was introduced.

This command was introduced.

Usage Guidelines An IP address and port are configured and identified as a permanent port (for example, a port to which the responder is permanently listening). If no IP address and port are configured, the responder handles only dynamic ports (for example, ports that are listened to when requested by a remote operation).

Task ID

Task ID monitor

Operations read, write

Examples The following example shows how to enable the IP SLA responder:

RP/0/0RP0RSP0/CPU0:router:hostname# configure

RP/0/0RP0RSP0/CPU0:router:hostname(config)# ipsla

RP/0/0RP0RSP0/CPU0:router:hostname(config-ipsla)# responder

RP/0/0RP0RSP0/CPU0:router:hostname(config-ipsla-resp)#

Cisco IOS XR System Monitoring Command Reference for the Cisco CRS Router, Release 4.2.x

219 OL-26517-02

IP Service Level Agreement Commands responder

Related Commands

Command

type udp ipv4 address, on page 327

Description

Configures a permanent port in the IP SLA Responder for UDP echo or jitter operations.

220

Cisco IOS XR System Monitoring Command Reference for the Cisco CRS Router, Release 4.2.x

OL-26517-02