Cisco IOS XR System Monitoring Command Reference for the Cisco

Diagnostics Commands show diagnostic schedule

show diagnostic schedule

To display the current scheduled diagnostic tasks, use the show diagnostic schedule command in Admin

EXEC modeSystem Admin EXEC mode.

show diagnostic schedule location node-id

Syntax Description

location node-id Displays the diagnostic schedule for a specified location. The node-id argument is entered in the rack/slot/module notation.

Command Default No default behavior or values

Command Modes Admin EXEC modeSystem Admin EXEC mode

Command History

Release

Release 3.3.0

Release 3.7.2

Modification

This command was introduced.

This command was introduced.

Usage Guidelines Use the show diagnostic schedule command to display scheduled diagnostic tasks for a specific location.

Note To specify a node using the node-id argument, use the rack/slot/module notation. For example, 0/0/CPU0 is a fully qualified location specification for a line card, 0/2/CPU0 is a fully qualified location specification for a line card, 0/7/CPU0 is a fully qualified location specification for a line card, 0/RSP0/CPU0 is a fully qualified location specification for a Route Switch Processor, and 0/RSP0/CPU0 is also a fully qualified location specification for a Route Switch Processor.

Task ID

Note To specify a physical layer interface module (PLIM) node using the node-id argument, use the following notation: rack/PLslot-number/SP. For example, 0/PL1/SP. PLIM diagnostic tests are supported.

For more information about running Cisco IOS XR diagnostics, refer to Cisco IOS XR Diagnostics.

Task ID diag

Operations read

Cisco IOS XR System Monitoring Command Reference for the Cisco CRS Router, Release 4.2.x

529 OL-26517-02

Diagnostics Commands show diagnostic schedule

Examples The following example shows how to display scheduled diagnostic tasks:

RP/0/0RP0RSP0/CPU0:router:hostname# admin

RP/0/0RP0RSP0/CPU0:router:hostname(admin)# show diagnostic schedule location 0/3/CPU0

Current Time = Tue Sep 27 12:41:24 2005

Diagnostic for LC 0/3/CPU0:

Schedule #1:

To be run daily 14:40

Test ID(s) to be executed: 1 .

Table 46: show diagnostic schedule Field Descriptions

Field

Current Time

Diagnostic for

Schedule

To be run

Test ID(s) to be executed

Description

Current system time.

Card for which the diagnostic is scheduled.

Schedule number.

Time at which the diagnostics are scheduled to run.

Tests to be run at scheduled time.

Related Commands

Command

diagnostic schedule, on page 486

Description

Configures a diagnostic schedule.

530

Cisco IOS XR System Monitoring Command Reference for the Cisco CRS Router, Release 4.2.x

OL-26517-02