Configure a Camera for Wired Ethernet. INSTEON Configuring Wi-Fi Camera, Wi-Fi Camera
INSTEON Wi-Fi Camera is an easy-to-use device that will give you peace of mind. It is equipped with a night vision feature that will allow you to see what is happening in your home even when it is dark. The camera also has a built-in microphone and speaker, so you can hear and talk to people in your home from anywhere in the world. You can use the Insteon app to configure and control your camera, and to receive alerts when motion is detected. The camera can be configured to use either a wired Ethernet connection or a Wi-Fi connection, so you can place it anywhere in your home.
Реклама
Реклама
Configure a Camera for Wired Ethernet
Mac or PC
Download and launch the
Camera Setup Assistant from your Mac or PC.
insteon.com/csa
Double-click the camera that you would like to configure.
Enter the camera’s default account credentials. When ready, click Log In.
Default User Name: “admin”
Default Password: blank
Click the button that corresponds to your computer’s internet browser. This guide assumes you are using Firefox,
Chrome or Safari.
37
Configure a Camera for Wired Ethernet
Mac or PC
Click Device Management Click Alias Settings
Give your camera a name. When ready, click Submit.
Click Users Settings
38
Configure a Camera for Wired Ethernet
Mac or PC
?
The maximum password length is 12 characters
The password must contain letters and numbers only; no special characters
(!@#$%^&*, etc.) are permitted
The password cannot contain spaces
If the Next button is disabled, your password does not meet the password restrictions.
Enter a password for the admin user account. This information is used to secure your camera.
When ready, click Submit.
When prompted, enter your camera’s new password and click Log In.
Click Basic Network Settings
39
Configure a Camera for Wired Ethernet
Mac or PC
Change the port from 80 to 25106.
If you are setting up more than one camera, increase the port number for each successive camera to ensure that every camera has a unique port number.
When ready, click Submit.
Close your browser and return to the
Insteon Camera Setup Assistant.
Write down the IP address displayed to the right of the camera name.
Right-click (or control-click on a Mac) and select Network Configuration.
Uncheck Obtain IP from DHCP
Server. IP Address, Subnet Mask,
Gateway and DNS Server should auto-populate.
?
If the fields are empty, enter the information gathered throughout this document.
Use Gateway IP Address for both Gateway and DNS
Server addresses.
40
Configure a Camera for Wired Ethernet
Mac or PC
Enter your camera password and click OK. It may take up to two minutes for your camera to restart.
Visit insteon.com/remoteaccess for instructions on configuring remote access.
You’re done setting up your
Insteon Wi-Fi Camera.
41
Изтегляне
Реклама