Configure a Camera for Wi-Fi. INSTEON Configuring Wi-Fi Camera, Wi-Fi Camera
INSTEON Wi-Fi Camera is an easy-to-use device that will give you peace of mind. It is equipped with a night vision feature that will allow you to see what is happening in your home even when it is dark. The camera also has a built-in microphone and speaker, so you can hear and talk to people in your home from anywhere in the world. You can use the Insteon app to configure and control your camera, and to receive alerts when motion is detected. The camera can be configured to use either a wired Ethernet connection or a Wi-Fi connection, so you can place it anywhere in your home.
विज्ञापन
विज्ञापन
Configure a Camera for Wi-Fi
Mac or PC
Download and launch the
Camera Setup Assistant from your Mac or PC.
insteon.com/csa
Double-click the camera that you would like to configure.
Enter the camera’s default account credentials. When ready, click Log In.
Default User Name: “admin”
Default Password: blank
Click the button that corresponds to your computer’s internet browser. This guide assumes you are using Firefox,
Chrome or Safari.
42
Configure a Camera for Wi-Fi
Mac or PC
Click Device Management Click Alias Settings
Give your camera a name. When ready, click Submit.
Click Users Settings
43
Configure a Camera for Wi-Fi
Mac or PC
?
The maximum password length is 12 characters
The password must contain letters and numbers only; no special characters
(!@#$%^&*, etc.) are permitted
The password cannot contain spaces
If the Next button is disabled, your password does not meet the password restrictions.
Enter a password for the admin user account. This information is used to secure your camera.
When ready, click Submit.
When prompted, enter your camera’s new password and click Log In.
Click Basic Network Settings
44
Configure a Camera for Wi-Fi
Mac or PC
Change the port from 80 to 25106.
If you are setting up more than one camera, increase the port number for each successive camera to ensure that every camera has a unique port number.
When ready, click Submit.
Close your browser and return to the Insteon
Camera Setup Assistant.
It can take up to two minutes for your camera to restart. When complete, it will reappear in the
Camera Assistant. Double-click your camera to return to the web interface.
Click Wireless LAN Settings Click Scan
45
Configure a Camera for Wi-Fi
Mac or PC
Select your Wi-Fi Network from the list. If you don’t see your network, ensure that you’ve connected the antenna to your camera.
Enter your Wi-Fi Network password and click Submit.
After clicking Submit, disconnect the ethernet cable from your camera and close your browser. It make take up to two minutes for your camera to restart.
If you do not disconnect the ethernet cable, your camera will not switch to
Wi-Fi.
Return to the Insteon Camera Setup
Assistant. Your camera should be automatically detected.
Write down the IP address displayed to the right of the camera name.
46
Configure a Camera for Wi-Fi
Mac or PC
Right-click (or control-click on a Mac) and select Network Configuration.
Uncheck Obtain IP from DHCP
Server. IP Address, Subnet Mask,
Gateway and DNS Server should auto-populate.
Enter your camera password and click
OK. It may take up to two minutes for your camera to restart.
Visit insteon.com/remoteaccess for instructions on configuring remote access.
You’re done setting up your
Insteon Wi-Fi Camera.
47
Use the web browser interface to configure advanced settings on your camera.
48
डाउनलोड
विज्ञापन