Care and cleaning. John Lewis JLBIOS651

52

Care and cleaning

Warning! Refer to Safety chapters.

Notes on cleaning

Clean the front of the oven with a soft cloth with warm water and a mild detergent.

Use a cleaning solution to clean metal surfaces.

Clean stains with a mild detergent.

Cleaning

Agents

Clean the cavity after each use. Fat accumulation or other residue may cause fire.

Everyday Use

Do not store the food in the oven for longer than 20 minutes. Dry the cavity with a soft cloth after each use.

Clean all accessories after each use and let them dry. Use a soft cloth with warm water and a mild detergent. Do not clean the accessories in a dishwasher.

Do not clean the non-stick accessories using abrasive cleaner or sharp-edged objects.

Accessories

How to remove: Shelf supports

Remove the shelf supports to clean the oven.

Step 1 Turn off the oven and wait until it is cold.

Oven User Manual

Step 2

Step 3

Step 4

Carefully pull the shelf supports up and out of the front catch.

Pull the front end of the shelf support away from the side wall.

Pull the supports out of the rear catch.

Install the shelf supports in the opposite sequence.

How to use: Pyrolytic cleaning

Clean the oven with pyrolytic cleaning.

Warning! There is a risk of burns.

Caution! If there are other appliances installed in the same cabinet, do not use them at the same time as this function. It can cause damage to the oven.

Turn off the oven and wait until it is cold.

Before the pyrolytic cleaning:

Remove all accessories.

Clean the oven floor and the inner door glass with warm water, a soft cloth and a mild detergent.

Do not fill the water tank during cleaning. It restarts the cleaning cycle.

Step 1

Step 2

Step 3

Step 4

Step 5

Turn on the oven.

Select: Menu / Cleaning / Cleaning. Press: .

Put the baking tray on the first shelf position to collect water from the water tank.

- press to start water tank emptying.

When the tank emptying ends remove the baking tray and removable shelf supports. Wipe the oven cavity and the inner door glass with a soft cloth. Press: .

, - press to select the cleaning mode. Press: .

Option Cleaning mode

Quick

Normal

Light cleaning

Normal cleaning

Intense Thorough cleaning

Duration

1 h

1 h 30 min

3 h

Oven User Manual 53

When the cleaning starts, the oven door is locked and the lamp is off.

To stop the cleaning before it is completed, turn off the oven.

The oven stays locked until it is cold.

Turn off the oven and wait until it is cold.

Cleaning Reminder

When the cleaning ends:

Clean the cavity with a soft cloth.

Remove the residue from the bottom of the cavity.

When the reminder appears, cleaning is necessary.

Use the function: Pyrolysis.

You can enable and disable the reminder in the menu: Basic Settings .

How to use: Descaling

Turn off the oven and wait until it is cold.

Before you start:

Remove all accessories.

Make sure that the water drawer is empty.

Duration of the first part: around 100 min

Step 1 Place the deep pan on the first shelf position.

Step 2

Step 3

Pour 250 ml of the descaling agent in the water drawer.

Step 4

Step 5

Fill the remaining part of the water drawer with water to the maximum level until the signal sounds or the display shows the message.

Select: Menu / Cleaning.

Turn on the function and follow the instruction on the display.

The first part of descaling starts.

Step 6 After the first part is over, empty the deep pan and put it back on the first shelf position.

Duration of the second part: around 35 min

Step 7

Step 8

Fill the remaining part of the water drawer with water to the maximum level until the signal sounds or the display shows the message.

When the function ends, remove the deep pan.

54 Oven User Manual

When this function works, the lamp is off.

Turn off the oven.

When descaling ends:

When the oven is cold, dry the cavity with a soft cloth.

Leave the oven door open and wait until the cavity is dry.

If some limestone residue remains in the oven after descaling, the display prompts to repeat the procedure.

Descaling reminder

There are two reminders which prompt you to descale the oven. You cannot disable the descaling reminder.

Type

Soft reminder

Hard reminder

Description

Recommends you to descale the oven.

Obligates you to descale the oven. If you do not descale the oven when the hard reminder is on, the steam functions are disabled.

These reminders activate each time you turn off the oven.

How to use: Rinsing

Before you start:

Turn off the oven and wait until it is cold.

Remove all accessories.

Step 1

Step 2

Step 3

Step 4

Step 5

Place the deep pan on the first shelf position.

Fill the water drawer with water to the maximum level until the signal sounds or the display shows the message.

Select: Menu / Cleaning / Rinsing.

Duration: around 30 min

Turn on the function and follow the instruction on the display.

When the function ends, remove the deep pan.

When this function works, the lamp is off.

Oven User Manual 55

How to use: Tank Emptying

Use it after cooking with steam heating function to remove the residual water from the water drawer.

Before you start:

Turn off the oven and wait until it is cold.

Remove all accessories.

Step 1

Step 2

Step 3

Step 4

Place the deep pan on the first shelf position.

Select: Menu / Cleaning / Tank Emptying.

Duration: 6 min

Turn on the function and follow the instruction on the display.

When the function ends, remove the deep pan.

When this function works, the lamp is off.

How to remove and install:

Door

You can remove the door and the internal glass panels to clean it. The number of glass panels is different for different models.

Warning! The door is heavy.

Caution! Carefully handle the glass, especially around the edges of the front panel. The glass can break.

Step 1

Step 2

Fully open the door.

Lift and press the clamping levers

(A) on the two door hinges.

A

A

Step 3 Close the oven door to the first opening position (approximately 70° angle). Hold the door at both sides and pull it away from the oven at an upwards angle. Put the door with the outer side down on a soft cloth on a stable surface.

56 Oven User Manual

Step 4

Step 5

Step 6

Step 7

Step 8

Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal.

Pull the door trim to the front to remove it.

Hold the door glass panels on their top edge one by one and pull them up out of the guide.

Clean the glass panel with water and soap. Dry the glass panel carefully. Do not clean the glass panels in the dishwasher.

After cleaning, do the above steps in the opposite sequence.

B

2

1

Step 9 Install the smaller panel first, then the larger and the door.

How to replace: Lamp

Warning! Risk of electric shock.

The lamp can be hot.

Step 1

Turn off the oven. Wait until the oven is cold.

Before you replace the lamp:

Step 2

Disconnect the oven from the mains.

Step 3

Put a cloth on the bottom of the cavity.

Oven User Manual 57

Top lamp

Step 1 Turn the glass cover to remove it.

Step 2

Step 3

Step 4

Side lamp

Remove the metal ring and clean the glass cover.

Replace the lamp with a suitable 300 °C heat-resistant lamp.

Attach the metal ring to the glass cover and install it.

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Remove the left shelf support to get access to the lamp.

Use a narrow, blunt object (e.g. a teaspoon) to remove the glass cover.

Clean the glass cover.

Replace the lamp with a suitable 300 °C heat-resistant lamp.

Install the glass cover.

Install the left shelf support.

58 Oven User Manual