advertisement
MENU
CH
1
4
7
2
5
8
0
3
6
9
CH
™ £ q
2 5
/
8
3
OK
PUSH JOG
NOTES:
● If you have programmed the VCR to timer-record 2 or more programs, the second program and those thereafter may not fit on the tape if you set the Auto SP/EP Timer mode to "ON".
In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.
● There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
● The Auto SP/EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work properly with any tapes other than the following: T-30, T-60,
T-90, and T-120.
31
Auto SP/EP Timer
If, when recording in SP mode, there is not enough tape to record the entire program, the VCR automatically switches to EP mode to allow complete recording. This feature is especially handy when recording a program of more than 2 hours in length.
For Example . . .
Recording a program of 140 minutes in length onto a 120minute tape
Approximately 110 minutes
SP mode
Approximately 30 minutes
EP mode
Total 140 minutes
Make sure you select “ON” at the Auto SP/EP Timer screen before performing timer programming.
ACCESS MAIN MENU
SCREEN
Press MENU.
1
2
3
4
ACCESS FUNCTION SET
SCREEN
Place the arrow next to "FUNCTION SET" by pressing
CH
5∞
or PUSH JOG
%fi
, then press OK.
ACCESS AUTO SP/EP
TIMER SCREEN
Place the arrow next to “AUTO SP/EP TIMER” by pressing CH
5∞
or PUSH JOG
%fi
, then press OK.
SELECT MODE
Place the arrow next to your choice (“ON” or
“OFF”) by press CH
5∞
or
PUSH JOG
%fi
.
AUTO SP/EP TIMER
= ON
OFF
PRESS ( 5 , ∞ ) TO SELECT
PRESS (MENU) TO END
5
RETURN TO NORMAL
SCREEN
Press MENU as many times as necessary.
advertisement