advertisement
38
NUMBER
(Ex.) To set remote control to RCA 80:
POWER
8 0
STOP
POWER
1
4
7
2
5
8
0
3
6
9
ENTER
CH
TV/CABLE/VCR
Release
SPECIAL FEATURES (cont.)
Satellite Receiver Multi-
Brand Remote Control
The VCR's remote control can control functions on the brands of satellite receivers listed below.
1
TURN ON THE SATELLITE
RECEIVER
Turn the power on using the satellite receiver’s remote control.
2
SET REMOTE CONTROL
MODE
Set the TV/CABLE/VCR switch on the VCR’s remote control to CABLE.
3
4
ENTER SATELLITE RECEIVER
BRAND
While holding down POWER on the VCR's remote control, use the NUMBER keys to enter the satellite receiver brand number from the chart below and then press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the satellite receiver, you don't have to repeat this step until you replace the remote control's batteries.
OPERATE SATELLITE
RECEIVER
First, press POWER to see if the satellite receiver’s power goes off as it should. If it does, try other functions (CH 5∞ and the NUMBER keys can be used to operate the satellite receiver).
●
For some brands of satellite receiver, you must press
ENTER after having pressed the NUMBER keys.
●
To return the remote to VCR control, set the TV/
CABLE/VCR switch to VCR.
NOTES:
●
Depending on the kind of satellite receiver, there may be cases where some or all functions cannot be operated using the remote control.
● It's not possible to set the remote control for both your cable box and your satellite receiver at the same time; you can only set the remote control to the brand of either one.
●
You have to subscribe to a satellite broadcaster to receive satellite channels.
SATELLITE BRAND NAME
RCA (DSS)
SONY (DSS)
PRIMESTAR
BRAND CODE
80
81
90
Hold down
Press in succession
advertisement