advertisement
28
G-Code Timer
Programming
Before G-Code Timer programming, see "G-Code Setup" on page 9.
TV/VIDEO
NUMBER
CANCEL
OK
NUMBER "8"
SP/EP
6 q
NUMBER "9"
MENU
TV/VCR
TIMER RECORDING (cont.)
1
2
3
4
5
LOAD A CASSETTE
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
● If you’re watching on channel 13, press TV/VIDEO to select the VIDEO mode. VIDEO is displayed on the front display panel.
ACCESS G-CODE SCREEN
Press MENU on the remote
G-CODE control.
● The clock must be set in order to access the G-
Code screen. If you haven’t set the clock, the
Main Menu screen appears when you press
PRESS NUMBER KEY(0-9)
PRESS (MENU) TO MAIN MENU
MENU. Refer to page 5 for the clock setting procedure.
ENTER G-CODE NUMBER
Press the appropriate NUMBER keys to enter the G-Code number printed in the TV listings for the TV program you wish to record.
●
To make corrections, press CANCEL and input the correct G-Code number.
●
If the G-Code number you input is incorrect,
"ERROR" may appear on the screen to advise you of the error. This happens when the G-Code number is for a program which has already passed. "ERROR" is displayed for about 4 seconds and the G-Code screen reappears (step 2).
CHECK INPUT DATA
Press OK and the Program screen appears.
The G-Code number you entered appears in the
Program screen. Check to
DATE
START
PROGRAM 1
(G-CODE 12345678)
7/10 WED
8:00 PM
STOP
CHANNEL
9:00 PM
8 SP make sure it’s accurate.
● To timer-record daily or weekly serials, press
PRESS (8=DAILY, 9=WEEKLY
SP/EP=REC SPEED)
PRESS (MENU) TO END
DAILY (NUMBER “8”) or WEEKLY (NUMBER “9”).
“DAILY” or “WEEKLY” appears on the Program screen.
●
If you made a mistake, press CANCEL and, after pressing MENU as many times as necessary to access the G-Code screen, input the correct G-Code number.
SET TAPE SPEED
Press SP/EP.
MENU
NUMBER
OK
6 q
CH
TIMER
MENU
29
6
7
CHECK/CORRECT INPUT
DATA
If the data is correct as it is, go to step 7 . If not, press
OK or PUSH JOG ™£ until the item you want to change begins to blink. Then press the appropriate
NUMBER keys or CH
5∞
to obtain the desired setting.
RETURN TO NORMAL
SCREEN
Press MENU as many times as necessary.
●
Press just once to access the Auto Timer screen
(
Z
pg. 34).
ENGAGE TIMER MODE
Press TIMER . The VCR turns off automatically.
8
NOTES:
● To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.
● In case of a power failure after programming, the VCR’s memory backup keeps your selections for 18 hours.
● Backup time becomes shorter as the unit's internal parts become old. When this occurs, please consult your nearby
JVC dealer.
PUSH JOG
advertisement