Remote Device Management. Case XLR 550

XLR 550 Manual

Statistics:

--------------------------------------------------------

Information PDUs (tx/rx) 0/0

Event PDUs (tx/rx) 0/0

Variable Request PDUs (tx/rx) 0/0

Variable Response PDUs (tx/rx) 0/0

Loopback Control PDUs (tx/rx) 2/0

Vendor Specific PDUs (tx/rx) 0/0

Received Not-supported code 0

KeepAlive Timeouts 0

XLR550> (enable)

4.11

Remote Device Management

This section describes a list of commands that manage the remote terminal(RT) device.

If an CO(central office) device is connected to a RT(remote terminal) device, you can manage remotely

RT device from CO device by using “ cpe ” command.

4.11.1

cpe

To manage the RT device.

Usage

Arguments keyword cpe <port name> <command>

<port name>

<command>

Description

Port Name connected to a RT device.

This feature is only supported on the 2BASE-TL port.

Command to execute on a RT device.

Note

You can this command only if device type is CO and 2BASE-TL port is up.

This command is effective only if efmoam is enabled.

Confirmation

See also, “ set devicetype ” , “ set efmoam ” .

Examples

[Example 11-1] display device type of remote device.

XLR550> (enable) show devicetype

Device Type: CO

XLR550> (enable) cpe s0 show devicetype

Device Type: RT

XLR550> (enable)

Revision 1.3a Page 59