advertisement
TH2515 Operation Manual
OFF is to turn off the bin beep function.
NG: Bin beep function is ON. When the result is not consistent with the bin setting, the beep will sound.
GD: Bin beep function is ON. When the result is consistent with bin setting, the beep will sound.
NG Color
OFF ： When the measurement result is different from the bin setting, there is no display. GREY :
When the measurement result is different from the bin setting, the corresponding bin will be displayed in grey; RED : When the measurement result is different from the bin setting, the corresponding bin will be displayed in red; GREEN : When the measurement result is different from the bin setting, the corresponding bin will be displayed in green.
GD Color
OFF ： When the measurement result conforms to the bin setting, there is no display. GREY : When the measurement result conforms to the bin setting, the corresponding bin will be displayed in grey; RED : When the measurement result conforms to the bin setting, the corresponding bin will be displayed in red; GREEN : When the measurement result conforms to the bin setting, the corresponding bin will be displayed in green.
---------------------------------------------------------------------------------------------------------
NOTE: NG is the abbreviation of not good while GD is the abbreviation of good.
---------------------------------------------------------------------------------------------------------
3.4
STATIS DISP
Touch the main menu or press [MEAS]. And then touch the soft key STATIS DISP to enter into the
STATIS DISP page shown as figure 3-4.
Figure 3-4 Statistic display
The function of this page is to count measurement data. It is workable to analyze the average value of results for multiple measurements, the PASS/FAIL rate and some engineering coefficients.
Details are as below.
14
advertisement