Editing an Existing Macro. CRS Sam4s ER-650

4. Continue to enter keystrokes until the macro is complete. Press ESC to end the macro recording and return to the MACRO PROGRAM screen. If you wish to add a function to a macro that is not located on the keyboard, or if you wish to include the CLEAR/ESC , Y/N , PAGE UP , or PAGE DOWN function to a macro string (these keys are used for editing purposes inside this program), press

PAGE DOWN to display a keycode list:

FUNCTION KEYCODE

--------------------

NLU#1 - NLU#80(1-80)

ONE 81

TWO 82

THREE 83

FOUR 84

FIVE 85

5. With the keycode list displayed, press PAGE DOWN and PAGE UP to find the function you wish to add to the macro. Type the numeric code number press

ENTER . The function is added to the macro.

Editing an Existing Macro

1. After selecting a macro to program the screen displays the keystrokes currently programmed.

1. ONE Å

2. TWO

3. THREE

4. FOUR

8. the key to advance the cursor to the line you wish to edit.

3. With the cursor pointing at a line, press (or select) the new function you wish to place in the macro sequence.

4. If you wish to remove a key stroke from a macro, replace the current function with the INACTIVE function by pressing the PAGE DOWN to display a keycode list, then enter

1 8 7 .

222

•

Program Mode Programming SAM4s ER-650