I
2
C bus specification STA350B, STA350BW the device address and if a match is found, it acknowledges the identification on the SDA bus during the 9 th
bit time. The byte following the device identification byte is the internal space address.
Following the START condition the master sends a device select code with the RW bit set to 0. The STA350Bx acknowledges this and then writes the byte of the internal address.
After receiving the internal byte address the STA350Bx again responds with an acknowledgment.
In the byte write mode the master sends one data byte, which is acknowledged by the
STA350Bx. The master then terminates the transfer by generating a STOP condition.
The multi-byte write modes can start from any internal address. The master generating a
STOP condition terminates the transfer.
7.4.1
7.4.2
7.4.3
7.4.4
Current address byte read
Following the START condition the master sends a device select code with the RW bit set to 1. The STA350Bx acknowledges this and then responds by sending one byte of data. The master then terminates the transfer by generating a STOP condition.
Current address multi-byte read
The multi-byte read modes can start from any internal address. Sequential data bytes are read from sequential addresses within the STA350Bx. The master acknowledges each data byte read and then generates a STOP condition, terminating the transfer.
Random address byte read
Following the START condition the master sends a device select code with the RW bit set to 0. The STA350Bx acknowledges this and then the master writes the internal address byte. After receiving the internal byte address, the STA350Bx again responds with an acknowledgement. The master then initiates another START condition and sends the device select code with the RW bit set to 1. The STA350Bx acknowledges this and then responds by sending one byte of data. The master then terminates the transfer by generating a STOP condition.
Random address multi-byte read
The multi-byte read modes can start from any internal address. Sequential data bytes are read from sequential addresses within the STA350Bx. The master acknowledges each data byte read and then generates a STOP condition, terminating the transfer.
32/94 DocID018572 Rev 7
