Setting the split frame and characters. Panasonic VQT3U71A(E), M1111TY0 -FJ

Add to My manuals
145 Pages

advertisement

Setting the split frame and characters. Panasonic VQT3U71A(E), M1111TY0 -FJ | Manualzz

2. Input/output signal settings

2-5-2. Setting the split frame and characters

Set the frame, character brightness and background of the split screens to be displayed on the multi view display.



Press the x

button to light its indicator, and display the

Multi View Display menu.



Use [F1] to display the MV Frame sub menu.

2-5-3. Setting the tally displays

Set the tally displays to be superimposed onto the split frame of the multi view display.

The red tally indicates material consisting of program outputs.

The green tally indicates material selected by the preset bus.

On the MV Frame sub menu, use [F5] to set the tally displays using the Tally item.



Use [F2] to set the split frame brightness and split frame display using the Frame item.

LUM0%,

LUM25%,

LUM50%,

LUM75%,

LUM100%

Off

Select one of these settings for the brightness of the split frame (gray scale).

The split frame is not displayed.

 Use [F3] to set the character brightness and character display using the Character item.

LUM0%,

LUM25%,

LUM50%,

LUM75%,

LUM100%

Off

Select one of these character (gray scale) brightness settings.

The characters are not displayed.

Neither is the character background shown.



Use [F4] to set whether the character background

(half-tone) is to be displayed using the Label item.

On

Off

The character background is displayed.

The character background is not displayed.

Red+Green

Both the red tally and green tally are displayed.

Red

Off

Only the red tally is displayed.

No tally displays are shown.

The red tally is not displayed during FTB operation while the program images have been completely faded out to a black screen. At this time, the green tally is displayed for images consisting of program images.

However, the red tally is displayed when a setting other than “White” or “Black” has been selected for the image used for fading out.

Refer to “1-7. FTB (Fade to Black)”.

The red tally and green tally signals are output from the tally output connector on the rear panel.

Refer to “4-1. Setting the GPI I/O”.

98

advertisement

Related manuals

advertisement

Table of contents