1. Safety precautions. INVT XG3-10kW, XG3-10KTL Single-phase On-grid Solar Inverter

Grid-tied single -phase solar inverter Safety precautions

1. Safety precautions

iMars series grid-tied solar inverters are designed and tested strictly in accordance with relevant international safety standards. As an electrical and electronic device, all relevant safety regulations must be strictly complied during installation, operation, and maintenance. Incorrect use or misuse may result in ：

 Injury to the life and personal safety of the operator or other people.

 Damage to the inverter or other property belonging to the operator or other people.

In order to avoid personal injury, damage to the inverter or other devices, please strictly observe the following safety precautions.

This chapter mainly describes various warning symbols in operation manual and provides safety instructions for the installation, operation, maintenance and use of the iMars series grid-tied solar inverters.

1.1Warning marks

Warning marks is alerting users to conditions which may cause serious physical injury or death, or damage to the device. They also tell users how to prevent the dangers. The warning marks used in this operation manual are shown below:

Mark Name Instruction Abbreviation

Danger

Serious physical injury or even death may occur if not follow relevant requirements.

Danger

Warning

Physical injury or damage to the device may occur if not follow relevant requirements.

Warning lectrostatic sensitive

Damage may occur if relevant requirements are not followed.

Forbid

Hot

Note

High temperature

Note

Do not touch the base of the inverter as it will become hot.

The procedures taken for ensuring proper operation.

1

Note