Shooting Video. Canon DC50

D119_PAL-E.book Page 32 Wednesday, December 20, 2006 10:27 AM

32

Recording

Recording

Shooting Video

Before You Begin Recording

Make a test recording first to check if the camcorder operates correctly. Since recordings made on a DVD-R or DVD-R

DL disc cannot be deleted, we recommend you use a DVD-RW disc to make the test recordings.

(

10)

2

The lens cover will open automatically.

Move the lens cover switch down to to open the lens cover.

3

Move the / switch to the

(Movies) position.

4

Press

Start/Stop

to begin recording.

• The recording starts; press

Start/Stop again to pause the recording.

• The DISC access indicator will flash while recording and will stay on briefly after pausing while the scene is recorded on the disc.

W

HEN YOU HAVE FINISHED RECORDING

1

Make sure that the DISC access lamp is off.

2

Turn off the camcorder.

3

Close the lens cover

( only) and the LCD panel.

4

Remove the disc.

IMPORTANT

Avoid the following actions while the DISC access indicator is on or flashing. Failing to do so may result in permanent data loss.

- Do not subject the camcorder to vibrations or strong impacts.

- Do not open the disc cover and do not remove the disc.

- Do not disconnect the power source or turn off the camcorder.

- Do not change the operating mode.

1

Move the power switch to ON to set the camcorder in CAMERA mode.

The red CAMERA indicator will turn on.

NOTES

About the recording time: By changing the recording mode you can change the recording time available on the disc ( 42).

When recording in bright places it may be difficult to use the LCD screen. In such case, use the viewfinder instead.

When recording in very loud places (such as fireworks shows or concerts), sound may become distorted or it may not be recorded at the actual levels. This is not a malfunction.