- Sports & recreation
- Fitness, gymnastics & weight training
- Treadmills
- Alliance Laundry Systems
- SWD439C
- User manual
Step 3: Connect Drain Hose to Drain Receptacle. Alliance Laundry Systems SWD439C
Add to My manuals
76 Pages
advertisement
Installation
Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp or by removing the shipping tape.
IMPORTANT: Drain receptacle must be capable of handling a minimum of 1-1/4 in. (3.2 cm) outside diameter drain hose.
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded tie-down strap from accessories bag and place around standpipe and drain hose and tighten strap to hold hose to standpipe. This will prevent the drain hose from dislodging from drain receptacle during use.
1
1
24" TO 36"
(61 TO 91.44 cm)
RECOMMENDED
HEIGHT
1
Retainer Clamp
Figure 6
SWD549N
SWD549N
1
2
3
SWD550N
3
2
SWD550N
Drain Hose
Beaded Tie-Down Strap
Standpipe 2" (5.08 cm) or 1-1/2" (4 cm)
Figure 7
10 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
800937
Sink Installation
For this type of installation, use the beaded tie-down strap (supplied in accessories bag), or use a large wire tie (available from your local hardware store) and secure the drain hose to the cabinet top hinge (refer to
Figure 8). This will prevent the drain hose from dislodging during use.
Installation
Laundry Tub Installation
For this type of installation, the drain hose MUST be secured to the stationary tub to prevent hose from dislodging during use. Use the beaded tie-down strap
(supplied in accessories bag) to secure hose.
1
1
1
2
2
SWD551N
SWD551N
Drain Hose
Tie-Down Strap (Wire tie or tape if necessary)
Figure 8
In-the-Wall Installation
For installations of this type, the drain hose MUST be secured to one of the inlet hoses using the beaded tie-down strap from accessories bag.
NOTE: End of drain hose must not be below 24 in.
1
2
1
2
2
SWD552N
SWD552N
Drain Hose
Tie-Down Strap (Tape if necessary)
Figure 10
800937
1
2
3
3
Drain Hose
Tie-Down Strap (Tape if necessary)
Inlet Hoses
Figure 9
H023I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11
advertisement
Related manuals
advertisement
Table of contents
- 12 Step 3: Connect Drain Hose to Drain Receptacle
- 14 Step 4: (Gas Dryer Only) Connect Gas Supply Pipe
- 15 Step 5: (Electric Dryer Only) Connect Electrical Plug
- 16 Step 6: Connect Dryer Exhaust System
- 17 Step 7: Position and Level the Unit
- 18 (Washer Only)
- 18 Step 9: Wipe Out Inside of Washer Drum and Dryer Drum
- 19 Step 10: Plug In the Washer and Dryer
- 19 Step 11: Check Installation
- 19 Moving Unit to a New Location
- 20 Heat Source Check
- 20 Electric Dryers
- 20 Gas Dryers
- 21 Electrical Requirements
- 21 Washer
- 22 Electric Dryer
- 24 Electrical Plug Connection
- 24 Three-Wire Plug
- 25 Four-Wire Plug
- 27 Electrical Requirements
- 27 Gas Dryer
- 29 Gas Requirements
- 31 Water Supply Requirements
- 31 Water Temperature
- 31 Water Pressure
- 31 Risers
- 32 Location Requirements
- 33 Dryer Exhaust Requirements
- 33 Exhaust System Materials
- 34 Make-Up Air Requirements
- 34 Make-Up Air Dos and Don’ts
- 34 Exhaust Direction
- 35 Exhaust System
- 36 Exhaust System Maintenance
- 36 Dryer Airflow
- 37 Information for Handy Reference
- 45 Piezas de repuesto
- 47 Instalación
- 47 Dimensiones y especificiones
- 48 Antes de comenzar
- 48 Herramientas
- 48 Ubicación
- 48 Ducto de escape
- 48 Requisitos eléctricos
- 49 Instalación de la unidad
- 49 Paso 1: Coloque la unidad cerca del área de instalación
- 49 Paso 2: Conecte las mangueras de suministro de agua
- 50 de desagüe
- 52 suministro de gas
- 53 suministro de energía eléctrica
- 54 Paso 6: Conecte el sistema de escape de la secadora
- 55 Paso 7: Coloque la unidad en su lugar y nivélela
- 56 (en la lavadora solamente)
- 56 la secadora
- 57 Paso 10: Enchufe la lavadora y la secadora
- 57 Paso 11: Revise la instalación
- 57 Desplazamiento de la unidad a un nuevo sitio
- 58 Revisión de la fuente de calor
- 58 Secadoras eléctricas
- 58 Secadoras a gas
- 59 Requisitos eléctricos
- 59 Lavadora
- 60 Secadoras eléctricas
- 62 Conexión eléctrica
- 62 Enchufe de tres conductores
- 63 Enchufe de cuatro conductores
- 65 Requisitos eléctricos
- 65 Secadoras a gas
- 67 Requisitos de la fuente de suministro de gas
- 69 Requisitos de suministro de agua
- 69 Temperatura del agua
- 69 Presión del agua
- 69 Tubos ascendentes
- 70 Requisitos del lugar
- 71 Requisitos del sistema de escape de la secadora
- 71 Materiales del sistema de escape
- 72 Requisitos de aire de reposición
- 72 Qué hacer y qué no hacer
- 72 Dirección del escape
- 73 Sistema de escape
- 74 Mantenimiento del sistema de escape
- 74 Flujo de aire de la secadora
- 75 Información de referencia