advertisement
Installation
Electrical Plug Connection
Three-Wire Plug
NOTE: The power cord (pigtail) is NOT supplied with the electric dryer. Type of pigtail and gauge of wire must conform to local codes and instructions.
The method of wiring the dryer is optional and subject to local code requirements.
NOTE: Connect the dryer to the power supply with the
MAXIMUM RATED VOLTAGE listed on the nameplate.
POWER SUPPLY
A typical
30-Amp
Three-wire
Receptacle
NEMA Type
10-30R
INTERMEDIATE
FUSE BOX (May be omitted if service entrance box is fused)
1
2
3
POWER SUPPLY
INTERMEDIATE
SHUT-OFF BOX
(May or may not be fused)
4
WALL RECEPTACLE
120 ± 12
V.A.C.
120 ± 12
V.A.C.
240 ± 12
V.A.C.
NOTE: Use COPPER WIRE only.
k
Shorter than 15
k (4.5 m) use 10 A.W.G.
Longer than 15
k (4.5 m) use 8 A.W.G.
1
2
3
L1 L2
PIGTAIL CONNECTION
3-Wire Grounded Neutral 120/240 Volt, 60 Hertz
AC 1 Phase Service Entrance Switch Box
(See NOTE above)
30 Ampere Fuses or Circuit Breaker
Neutral Wire
4
5
6
7
5
6
7
L1 L2
DIRECT CONNECTION
Metallic or Non-Metallic Sheathed Cable
(Copper wire only)
Pigtail to Dryer (See NOTE above)
Neutral
Terminal Block in Dryer
D816I
1. Remove access cover from rear of dryer.
Figure 26
2. Use a strain relief and insert end of power cord through power supply hole.
22
Figure 27
D695I
Figure 28
D696I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
800937
advertisement