advertisement
Installation
Location Requirements
Select a location with a solid floor.
The unit must not be installed or stored in an area where it will be exposed to water and/or weather.
Leveling legs can be adjusted from inside the unit with a 7/8 in. deep well socket. All four legs must rest firmly on the floor so the weight of the unit is evenly distributed. The unit must not rock and must be level from side-to-side and front-to-back.
IMPORTANT: Unless completely assembled, DO
NOT slide the unit across the floor. DO NOT slide the unit more than four feet once the leveling legs have been extended, as the legs and the base could become damaged.
The unit needs sufficient clearance and an adequate air supply for proper operation and ventilation, and for easier installation and servicing. (Minimum clearances are shown in Figure 41.
C
D
E
E
A B
SWD453N
Area
A
B
C
D
E
Left Dryer Side
Right Dryer Side
Dryer and Exhaust Duct Clearances
Description
Dryer Top
Dryer Rear
Exhaust Duct Clearance to Combustible Materials
NOTE: Shaded areas indicate adjacent structure.
Minimum Clearance
0" (0 cm)
0" (0 cm)
6" (15.24 cm)
2" (5.1 cm)
2" (5.1 cm)
Figure 41
SWD453N
30 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
800937
advertisement