Nightlight. British Telecom Digital Baby Monitor 300, PaperJet 300, 77497

Using your BT Digital Baby Monitor 300 15

Nightlight

You can set a comforting nightlight on the

Baby unit. There are three levels of brightness.

Switch Baby unit nightlight on/off

1. To switch on, press either the or button.

It will take 3 seconds to illuminate to the highest brightness level.

2. To switch off, either press and hold the button for 2 seconds or keep pressing the button until it reaches the level past the lowest brightness level.

It will take 3 seconds to completely switch off.

Adjust the nightlight brightness

1. Press the button to increase the brightness.

2. Press the button to decrease the brightness.

The Baby unit must be switched on for the nightlight to work, but doesn’t need to be linked to the Parent unit.

The default brightness level is High.

Talk back

You can use the Parent unit Talk back feature as a one way intercom to comfort and reassure your baby. By speaking into the Parent unit your baby will hear your voice from the Baby unit.

Please note that when using Talk back you will not be able to hear your baby until you release the

button.

You will be able to activate

Talk back mode even if other functions have been activated at the Baby unit e.g. Nightlight on.

If you experience any problems, please call the Helpline on Freephone 0800 145 6789* or visit bt.com/producthelp

2250 Baby Monitor 300 UG Iss2.[2].indd 15 10/04/2014 11:06

16 Using your BT Digital Baby Monitor 300

Do not press the button when the Baby unit and

Parent unit are positioned in the same room. High-pitch noise will be generated if the

button is pressed when the

Baby unit and Parent unit are close to each other or within

3 metres distance.

When using Talk back, hold the Parent unit approximately

30cm in front of your mouth when talking to baby.

1. Press and hold down the button on the Parent unit to speak to your baby.

Whilst the button is depressed the green Link indicators will flash on both units.

Parent unit battery LED indicator (top of unit)

When the Parent unit is on charge, the battery LED will be solid red. When the power is removed, the

LED will switch off. When the battery is low, the LED will flash.

Find

You can press the button on the Baby unit to make the Parent unit sound an alert beep to help you find it if it’s been misplaced. If the Parent unit loudspeaker volume had been muted (or set to volume off), the volume level will be reset to the default setting of Level 3.

1. Press on the Baby unit. The paging alert will sound at the Parent unit.

2. To stop the alert, press any button on the Parent unit or press the button again on the Baby unit.

If no button is pressed after 2 minutes then the alert will automatically stop.

If you experience any problems, please call the Helpline on Freephone 0800 145 6789* or visit bt.com/producthelp

2250 Baby Monitor 300 UG Iss2.[2].indd 16 10/04/2014 11:06