Notation convention for describing the table. Schneider Electric XBTF / TXBTF Graphic Terminals

PDF

Dokument

2. Dialog table content

The number of words in the table depends on the choice of states and commands that are to be processed during the dialog. You may add or delete items as you choose.

Notation convention for describing the table

NOTE

%MWn word of 16 bits with address n.

%MWn, i : bit i of word n.

The address n is taken as the table's start address.

The table comprises a maximum of 135 words.

The description below gives the content of the various dialog table words; refer to the XBT-L1000 software's on-line help for further information on the various words.

The word number is adapted in accordance with the words of the dialogue table used. The words are addressed in the order established in the "available functions".

Ex.

PLC <-- XBT: Terminal writes the corresponding word(s) in the PLC.

PLC --> XBT: Terminal reads the corresponding word(s) in the PLC.

PLC <--> XBT: Terminal and the PLC can modify the corrresponding word(s) in the PLC.

Graphic Magelis

C - 9

2. Dialog table content

Select the Configuration/Dialog table menu.

Check the Use dialog table option.

Click Modify to change the address of the beginning of table %MW100.

In the Function selections list, delete or add the functions required by the application by means of the Add Function or Delete Function buttons to obtain the following list:

Once creation is completed, save the application using the File/ Save menu.

C - 10

Graphic Magelis

2. Dialog table content

%MWn+13

%MWn+14

%MWn+15

%MWn+16

%MWn+17

%MWn+18

%MWn+19

%MWn+20