Assigning the static function keys. Schneider Electric XBTF / TXBTF Graphic Terminals

3. Creating the application

Assigning the static function keys

In order to assign the static function keys:

Note

1. Select the Configuration/Function Keys menu. The front panel of the terminal will then be displayed.

2. Double click the required function key (For example: F1).

3. Select the toggle command type.

4. Click Ok to confirm.

Bits associated with the dialog static function keys that can be used in the PLC application

A reserved word in the dialog table indicates the status of the function keys in the form of a word bit: bit at 1 = key pressed.

In our example the word %MW100 is used.

%MW100

Bit 1 Bit 0

F2 F1

Bits B0 and B1 are associated with the F1 and F2 command keys.

E

Graphic Magelis

E - 27