- No category
advertisement
Part III, Chapter 49: Power Signal Mapping L-761e_2
49 Power Signal Mapping
provides signal mapping for the SOM power signals.
The Signal column specifies the signal name used on the phyCORE-Connector and throughout the phyCORE-AM3517 schematics. The SOM column specifies the pin number on the phyCORE-Connector on the SOM (see
). The Expansion Bus column specifies the pin number on the GPIO expansion bus connector (see
Chapter 26 ) on the Carrier Board. The Patch Field column specifies the location of the
signal on the GPIO Expansion Board patch field.
Table 49-1. Power Signal Mapping
Signal
VIN
VIN
VCC_1V8
VCC_1V8
VDDSHV
VDDSHV
GND
SOM
1D
2D
4D
5D
6D
7D
2A, 7A, 12A, 17A, 22A,
27A, 32A, 37A, 42A, 47A,
52A, 57A, 62A, 67A, 72A,
77A, 4B, 9B, 14B, 19B,
24B, 29B, 34B, 39B, 44B,
49B, 54B, 59B, 64B, 69B,
74B, 79B, 7C, 12C, 17C,
22C, 27C, 32C, 37C, 42C,
47C, 52C, 57C, 62C, 67C,
72C, 77C, 3D, 9D, 14D,
19D, 24D, 29D, 34D, 39D,
44D, 49D, 54D, 59D, 64D,
9D, 74D, 79D
Expansion Bus
1D
2D
4D
5D
6D
7D
2A, 7A, 12A, 17A, 22A,
27A, 32A, 37A, 42A, 47A,
52A, 57A, 62A, 67A, 72A,
77A, 4B, 9B, 14B, 19B,
24B, 29B, 34B, 39B, 44B,
49B, 54B, 59B, 64B, 69B,
74B, 79B, 7C, 12C, 17C,
22C, 27C, 32C, 37C, 42C,
47C, 52C, 57C, 62C, 67C,
72C, 77C, 3D, 9D, 14D,
19D, 24D, 29D, 34D, 39D,
44D, 49D, 54D, 59D, 64D,
9D, 74D, 79D
Patch Field
1A, 2C
1A, 2C
2C, 1D
2C, 1D
2D
2F
3C, 4C, 7C, 8C, 9C, 12C,
13C, 14C, 17C, 18C, 19C,
22C, 23C, 24C, 27C, 29C,
30C, 31C, 34C, 35C, 36C,
39C, 40C, 41C, 44C, 45C,
46C, 48C, 49C, 50C, 51C,
54C, 4D, 5D, 6D, 9D, 10D,
11D, 14D, 15D, 16D, 19D,
20D, 21D, 24D, 25D, 26D,
28D, 31D, 32D, 33D, 36D,
37D, 38D, 41D, 42D, 43D,
46D, 47D, 48D, 51D, 52D,
54D
© PHYTEC America LLC 2012 108
advertisement
Related manuals
advertisement
Table of contents
- 11 Part I: PCM-048/phyCORE-AM3517 System on Module
- 12 1 Introduction
- 14 1.1 Block Diagram
- 15 1.2 View of the phyCORE-AM
- 17 2 Pin Description
- 29 3 Jumpers
- 32 3.1 Jumper Settings
- 35 4 Power
- 35 4.1 Primary System Power (VIN & VIN_3V3)
- 35 4.2 Secondary Battery Power (VBAT)
- 35 4.3 PMIC Supplies (U2)
- 36 4.4 RTC Supplies (U2)
- 36 4.5 Selecting Shunt Resistors for Current Measurements
- 36 4.6 Voltage Supervisor (U2, U21)
- 38 5 External RTC (U22)
- 39 6 System Configuration and Booting
- 42 6.1 Boot Process
- 43 7 System Memory
- 43 7.1 SDRAM (U8, U9)
- 43 7.2 NAND Flash (U16)
- 44 7.3 EEPROM (U13)
- 44 7.4 Memory Map
- 45 8 Serial Interfaces
- 45 8.1 RS-232 Transceiver (U15)
- 45 8.2 Ethernet PHY (U12)
- 45 8.3 USB OTG (U1)
- 46 8.4 USB1 Host (U1, U7)
- 47 9 Debug Interface (X1)
- 48 10 Touch Screen Controller (U25)
- 49 11 General Purpose Memory Controller (U2)
- 50 12 LCD LVDS Transmitter
- 51 12.1 LVDS and SOM I/O Voltage (J23)
- 52 13 AM3517 IO and GPMC Bus Voltage
- 53 14 Technical Specifications
- 55 15 Hints for Handling the phyCORE-AM
- 56 Part II: PCM-961/phyCORE-AM3517 Carrier Board
- 57 16 Introduction
- 58 17 Overview of Peripherals
- 61 18 Jumpers
- 65 19 phyCORE-AM3517 SOM Connectivity
- 66 20 Power
- 66 20.1 Wall Adapter Input (X9)
- 67 20.2 Power over Ethernet (PoE)
- 68 20.3 Lithium-Ion Battery
- 68 20.4 3.3V Supply (U27)
- 68 20.5 1.8V Supply (U31)
- 69 20.6 Current Measurement
- 70 21 JTAG Connectivity
- 72 22 Audio Interface
- 74 23 Ethernet Connectivity
- 75 24 USB Connectivity
- 77 25 LCD and DVI Connectivity
- 80 25.1 DVI Connector
- 80 25.2 LVDS Connectors
- 81 25.3 TTL LCD Connector
- 82 26 GPIO Expansion Connector
- 83 27 RS-232 Connectivity
- 87 28 SD/SDIO/MMC Connectivity
- 89 29 CAN (Controller Area Network) Interface
- 90 30 Wireless Connector
- 92 31 TV Out
- 93 32 Camera Interface
- 95 33 User Buttons
- 97 34 User LEDs
- 98 35 Boot Mode Selection
- 102 36 System Reset Button
- 103 Part III
- 103 Part III: PCM-988/GPIO Expansion Board
- 104 37 Introduction
- 106 38 System Signal Mapping
- 107 39 GPMC Signal Mapping
- 109 40 UART Signal Mapping
- 110 41 I²C Signal Mapping
- 111 42 GPIO Signal Mapping
- 112 43 USB Signal Mapping
- 113 44 CAN Signal Mapping
- 114 45 Ethernet Signal Mapping
- 115 46 HDQ Signal Mapping
- 116 47 McBSP Signal Mapping
- 117 48 SPI Signal Mapping
- 118 49 Power Signal Mapping
- 119 Revision History