Installation Connectible Devices
■
The intercom system and the “DoorLine” module should be set to their factory settings.
■
In the PBX Configuration: Ports: a/b: Change menu in the Configurator, select
Doorstation 2-wire under Type. Activate the Actuator option, if you want to use the actor port of the OpenCom 100 instead of the “DoorLine” relay. The
“DoorLine” actor can be operated only when the speech channel is open at the same time. The internal actor can be operated at any time.
■
The “DoorLine” intercom system has a number of bell keys to which you can assign different call numbers in the PBX Configuration: Ports: Doorbell menu in the Configurator.
■
You can call the “DoorLine” intercom system by entering the code procedure
*102
.
■
The “DoorLine” intercom system can be connected to any a/b port. However, you can use only one “DoorLine” with the OpenCom 100.
For details on installing and configuring the “DoorLine” intercom system, refer to the product user guide.
The intercom system should be installed by qualified personnel only as sensor/ actor contacts will need to be connected to the “DoorLine” module.
3.9.4 COM Port
Please note:
The connection line for the COM port can be up to three metres long.
A PC for configuring the OpenCom 107 or transmitting call data can be connected to the COM port. This call data can be evaluated in detail with the call charge registration program OpenCount.
3.9.5 LAN Port
Using the LAN port (Ethernet) you can integrate an OpenCom 107 into your corporate network (local area network), and thus use it, among other things, as an IP router for accessing the Internet.
28
