Configuration Examples OpenCom 107 in a LAN with an IP-enabled Server
Note: To access the OpenCom 107 under the same IP address after a restart, you must specify this IP address permanently on a DHCP server. On a DHCP server it is possible to link the MAC address of a network card with a specific IP address. You will find details in the server documentation.
7.4.2 Internet Access
You can also use the OpenCom 107 as an Internet access server in a LAN with an
IP-enabled server. To do this, you must enter the OpenCom 107 IP address on the server as the default gateway. In addition, you must edit the internal DNS server configuration so that the resolution of external DNS names is forwarded to the
OpenCom 107.
In this example, the Internet connection is established from a workstation via the server, which in turn requests Internet access from the OpenCom 107.
There are two different ways of suitably configuring the internal DNS server. You can enter the OpenCom 107 IP address as a DNS forwarder. If you require access to extended DNS information, you can also configure the DNS server for a recursive
DNS request without the DNS forwarder. For further explanation, refer to the DNS server documentation.
ISP
(DNS)
S
0
OpenCom
(Internet)
S
0
Net S
0
int
Server
(DHCP, RAS, int. DNS)
S
0
Net
Ext.
PC
PC 1 PC 2
S
0
Net Hub Net
The OpenCom 107 as a DNS server in a LAN with an IP server
60
