PBX Networking
9.
PBX Networking
OpenCom 107 provides all the features necessary for PBX networking. You need
PBX networking in the following cases:
■
To operate the OpenCom 107 as a subsidiary system on another PBX. This will also allow you to use the OpenCom 107 as a DECT server, for example.
■
To network the OpenCom 107 with an OpenCom 1000. In this way you can use the OpenCom 107 as a PBX for a branch office, for instance.
■
To network several OpenCom 107s into a PBX system.
■
To use flexible configuration possibilities of trunk lines for a OpenCom 107.
All settings that affect the configuration of PBX networking can be found in the
Configurator menu PBX Configuration: Trunks and in the PBX Configuration:
System: Settings dialogue under System linking. Refer also refer to the corresponding help topics in the OpenCom 107 online help.
You can use ISDN point-to-point connections (Q.SIG or DSS1 protocol) or IP connections (Q.SIG-IP protocol) for TK system networking.
Note: If you do not need the features of PBX networking, the simplified configuration is sufficient in most cases. For this purpose, assign the preconfigured trunk groups (bundles) Multi-terminal access or System access to the ports.
The preconfigured route called External trunk now makes it possible to seize an external line immediately or by first dialling the prefix “0”. You can rename the preconfigured bundle and the preconfigured route if required, but you cannot delete them.
83
