Configuring the Processor with ProWORX PTQ-DNPS ♦ Quantum / Unity Platform

Distributed Network Protocol Interface Module

4 Configuring the Processor with ProWORX

When you use ProWORX 32 software to configure the processor, use the example SaF file provided on the ProTalk Solutions CD-ROM.

Important Note: Proworx software does not report whether the PTQ module is present in the rack, and therefore is not able to report the health status of the module when the module is online with the Quantum processor. Please take this into account when monitoring the status of the PTQ module.

1

Run the Schneider_alliances.exe application that is installed with the

Proworx 32 software:

2

Click on Import…

ProSoft Technology, Inc.

April 22, 2008

Page 33 of 153

PTQ-DNPS ♦ Quantum / Unity Platform

Distributed Network Protocol Interface Module

Configuring the Processor with ProWORX

3

Select the .SaF File that is located at the CD-ROM shipped with the PTQ module.

4

After you click on Open you should see the PTQ modules imported (select

I/O series as Quantum):

Page 34 of 153 ProSoft Technology, Inc.

April 22, 2008

Configuring the Processor with ProWORX PTQ-DNPS ♦ Quantum / Unity Platform

Distributed Network Protocol Interface Module

Now you can close the Schneider alliances application and run the Proworx 32 software. At the Traffic Cop section, select the PTQ module to be inserted at the slot:

ProSoft Technology, Inc.

April 22, 2008

Page 35 of 153

PTQ-DNPS ♦ Quantum / Unity Platform

Distributed Network Protocol Interface Module

Configuring the Processor with ProWORX

Page 36 of 153 ProSoft Technology, Inc.

April 22, 2008