advertisement
4.6
RL3 Switching
4.6.1
SNAT (Source NAT)
Source NAT (SNAT) is the most common form of NAT. SNAT changes the source address of the packets passing through the switch. SNAT is typically used when an internal (private) host needs to initiate a session to an external (public) host.
4.6.1.1
Global Settings
To access this page, click L3 Switching > SNAT > Global Settings.
Figure 4.53 L3 Switching > SNAT > Global Settings
The following table describes the items in the previous figure.
Item
Interface
Auto Mode
Apply
Description
Click the drop-down menu to select the interface.
Select Enabled or Disabled to setup the auto mode.
Click Apply to save the values and update the screen.
The ensuing table for Global Information settings are informational only and display the following: Information Name and Information Value.
4.6.1.2
Entry Settings
To access this page, click L3 Switching > SNAT > Entry Settings.
Figure 4.54 L3 Switching > SNAT > Entry Settings
The following table describes the items in the previous figure.
Item
Interface
Original Source IP
Address
Original Source IP
Mask
Description
Click the drop-down menu to select the interface.
Define the original source IP address.
Define the original source IP mask.
64 EKI-9628G User Manual
advertisement