advertisement
5.7. Settings menu
The menu contains Hardware- and Software-related settings and information about connected device. The content of the tabs is also device-dependent.
5.7.1. Configuration
Settings about establishing the connection to the desired device are available on this tab.
Figure 5-7. Configuration tab in the Settings menu
IP Configuration
The IP address and TCP/IP port can be set up here.
Obtain IP address automatically
By selecting the Obtain IP address automatically option, the device gets the IP address from the DHCP server on the LAN, or if DHCP server is not present, it gets an AutoIP address from 169.254.xxx.xxx domain. Set BOOTP, DHCP and AutoIP settings according to your network requirements. Always press the Apply settings button to save changes.
Info: Load default button restores the default network settings (fix IP) to the device: IP Address:
192.168.254.254, Subnet Mask: 255.255.0.0, Default Gateway: 0.0.0.0.
Info: When serial port is used for connection, these settings cannot be changed.
5.7.2. Device information
Basic information about connected device and installed cards are listed on this tab.
Page 34 / 49
Figure 5-8. Device information tab
Section 5. Software control
– using Lightware Device Controller (LDC)
advertisement
Related manuals
advertisement
Table of contents
- 7 INTRODUCTION
- 9 CONTROLS AND CONNECTIONS
- 11 DVI input
- 12 RS-232/RS-422 control port
- 13 TECHNOLOGIES
- 13 Common problems related to EDID
- 16 OPERATION
- 16 TAKE / AUTOTAKE modes
- 16 Control lock
- 16 Switching
- 17 Presets operations
- 18 VIEW current state
- 18 Output lock
- 19 Changing and viewing current protocol
- 19 Reset factory default DVI signal settings
- 19 Reset factory default (static) IP address
- 20 – USING LIGHTWARE DEVICE CONTROLLER (LDC)
- 24 Grid view
- 26 Tile view
- 29 Preset operations
- 31 About EDID memory
- 32 Changing emulated EDID
- 32 Exporting an EDID
- 32 Importing an EDID
- 32 EDID Summary window
- 33 Editing an EDID
- 33 Creating an EDID (Easy EDID Creator)
- 33 Deleting EDID(s)
- 34 Configuration
- 34 Device information
- 35 User preferences
- 37 – USING THE BUILT-IN WEBPAGE
- 38 PROGRAMMERS’ REFERENCE
- 39 View connection on a specified output
- 39 Switch one input to one output
- 40 Switch one input to all outputs
- 40 View connection on all outputs
- 40 View mutes on all outputs
- 40 Mute specified output
- 41 Unmute specified output
- 41 Save preset to the specified memory location
- 41 Load preset from the specified location
- 41 View product type
- 41 View serial number
- 42 View firmware version of the CPU
- 42 View firmware for all controllers
- 42 Error responses
- 43 – BY LIGHTWARE MATRIX FIRMWARE UPDATER
- 47 APPENDIX
- 49 VERSION APPLICABILITY
- 49 WARRANTY
- 49 DOCUMENT REVISION HISTORY